Processor heads have too many pivots to hand-grease
A harvester head is a dense cluster of fast-cycling pins and bearings caked in sap and dirt. Manual greasing can't keep every point fed during a working shift.
INDUSTRIAL VERTICAL
Reliability for Forestry and Logging Equipment
Harvesters, forwarders, and processor heads run remote sites on brutal duty cycles, packed with pivots and exposed to dirt, sap, and debris. Armor distributes the automatic lubrication and contamination-control parts that keep the head moving and cut the long haul back to the shop.
Where Forestry reliability programs run into trouble
Three issues we hear most from forestry maintenance and reliability teams.
Remote sites make every failure expensive
A missed grease point in the woods is a long, costly recovery. Uptime depends on lubrication that happens automatically, far from the shop.
Sawdust, sap, and water foul hydraulics
Debris and moisture contaminate reservoirs fast on a machine that lives outdoors. Contamination control is what keeps the hydraulics and gear oil in spec.
Solutions for forestry operations
Application-level guidance with the products that solve them.
Automatic Lubrication Systems
Centralized systems pump grease from a single reservoir through metering valves to dozens of bearing points on a programmed cycle. Armor distributes the pumps, controllers, distribution valves, and tubing that build them.
Read moreBearing Lubrication
Bearings fail when grease film thins below the critical separation point. Armor distributes the automatic lubrication systems and grease-monitoring tools that keep film thickness consistent and predictable, regardless of duty cycle.
Read moreContamination Control
Contamination is the leading cause of premature bearing and hydraulic failures. Armor distributes the breathers, filters, and isolation hardware that keep particulates and water out of your reservoirs.
Read moreBrands we distribute for forestry
Common questions
Why run automatic lubrication on a harvester head?
The head's pins cycle constantly under contamination, and idle greasing time is lost production. An automatic system delivers metered grease to every point while the head works — so the bearings stay fed and the operator stays cutting instead of greasing.
How do you keep hydraulics clean working in the woods?
Desiccant breathers on the reservoir block the dust and moisture the machine breathes in, and offline filtration polishes the oil back to a cleanliness target. Together they stop the contamination that drives valve and pump wear on forestry carriers.
What about cold-weather and seasonal operation?
Lubricant and breather selection both depend on the temperature envelope — a grease and a breather that work in summer may not in a hard freeze. Send the operating range and we'll match the system to it.